Sculpey, foam and latex head

After my tutorial, it was suggested that I try adding very fine sporting injury foam dipped in latex and applied with spray mount ontop of a sculpey head. Once layered it can look like paper.

Firstly I wound some wadding around the eyebrow armature. I then sprayed a light layer of spray mount over the head and applied the foam with almost dried latex onto this. I used a coctail stick to tease it into the ridges on the face.

Once I covered the whole head I added bith of ripped up book page onto the surface.
I was surprised at the end result that it did have a papery quality to it. However it was also quite shiney due to the application of the latex so I would like to test this head under camera to see if it does look too shiney.